I tried today the Filter button on the bottom of max2curve tool.
It behaves as expected at first glance - it removes the histogram outside the
specified k-bounds. Later I learned that this filtering is not permanent - it
seems not possible to apply gird statistics on the filtered map... the full histogram
appears again. Similar the save button saves the full information as in the original
max file... I hoped, I can remove effectively a lot from the grids and then paste them
together...( I am using sesarray-2.0.3)
Another suggestion maybe too dangerous to be abused, but it could be nice
to have a slider for kmin and kmax to adjust the lines for cutting visually and then
pass the values to the filter.
All geopsy forums are in their very early stage. So a restricted number of forums has been created. If your question does not fit into one of the available categories, post here.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest